ITGB1 ELISA Kit
-
- Target See all ITGB1 ELISA Kits
- ITGB1 (Integrin beta 1 (ITGB1))
-
Reactivity
- Mouse
- Detection Method
- Colorimetric
- Method Type
- Sandwich ELISA
- Detection Range
- 0.312 ng/mL - 20 ng/mL
- Minimum Detection Limit
- 0.312 ng/mL
- Application
- ELISA
- Sample Type
- Cell Lysate, Tissue Homogenate
- Analytical Method
- Quantitative
- Specificity
- This assay has high sensitivity and excellent specificity for detection of Integrin Beta 1 (ITGb1). No significant cross-reactivity or interference between Integrin Beta 1 (ITGb1) and analogues was observed.
- Sensitivity
- 0.116 ng/mL
- Featured
- Discover our best selling ITGB1 ELISA Kit
- Top Product
- Discover our top product ITGB1 ELISA Kit
-
-
- Comment
-
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
- Assay Time
- 3 h
- Plate
- Pre-coated
- Protocol
- The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Integrin Beta 1 (ITGb1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Integrin Beta 1 (ITGb1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Integrin Beta 1 (ITGb1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Integrin Beta 1 (ITGb1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
- Assay Precision
-
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Integrin Beta 1 (ITGb1) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Integrin Beta 1 (ITGb1) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12% - Restrictions
- For Research Use only
-
- Handling Advice
- The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.
- Storage
- 4 °C,-20 °C
- Storage Comment
- -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.
- Expiry Date
- 4-8 months
-
- Target See all ITGB1 ELISA Kits
- ITGB1 (Integrin beta 1 (ITGB1))
- Alternative Name
- Integrin Beta 1 (ITGB1 Products)
- Synonyms
- CD29 ELISA Kit, FNRB ELISA Kit, GPIIA ELISA Kit, MDF2 ELISA Kit, MSK12 ELISA Kit, VLA-BETA ELISA Kit, VLAB ELISA Kit, 4633401G24Rik ELISA Kit, AA409975 ELISA Kit, AA960159 ELISA Kit, ENSMUSG00000051907 ELISA Kit, Fnrb ELISA Kit, Gm9863 ELISA Kit, gpIIa ELISA Kit, cd29 ELISA Kit, fnrb ELISA Kit, gpiia ELISA Kit, itgb1 ELISA Kit, mdf2 ELISA Kit, msk12 ELISA Kit, vla-beta ELISA Kit, vlab ELISA Kit, itgb1-a ELISA Kit, itgb1-b ELISA Kit, integrin subunit beta 1 ELISA Kit, integrin beta 1 (fibronectin receptor beta) ELISA Kit, integrin subunit beta 1 S homeolog ELISA Kit, integrin beta 1 ELISA Kit, integrin subunit beta 1 L homeolog ELISA Kit, ITGB1 ELISA Kit, Itgb1 ELISA Kit, itgb1.S ELISA Kit, LOC100009173 ELISA Kit, itgb1.L ELISA Kit
- Background
-
Gene Name: Integrin Beta 1
Gene Aliases: CD29, MSK12, ITG-B1, FNRB, GPIIA, MDF2, MSK12, VLAB, Fibronectin Receptor Beta Polypeptide, Antigen CD29 Includes MDF2, Glycoprotein IIa, VLA-4 subunit beta
- Gene ID
- 16412
- UniProt
- P09055
- Pathways
- Cell-Cell Junction Organization, Regulation of G-Protein Coupled Receptor Protein Signaling, CXCR4-mediated Signaling Events, Signaling of Hepatocyte Growth Factor Receptor, Integrin Complex, SARS-CoV-2 Protein Interactome
-