ITGA9 ELISA Kit
-
- Target See all ITGA9 products
- ITGA9 (Integrin alpha-9 (ITGA9))
- Reactivity
- Human
- Detection Method
- Colorimetric
- Method Type
- Sandwich ELISA
- Detection Range
- 0.156 ng/mL - 10 ng/mL
- Minimum Detection Limit
- 0.156 ng/mL
- Application
- ELISA
- Sample Type
- Cell Lysate, Tissue Homogenate
- Analytical Method
- Quantitative
- Specificity
- This assay has high sensitivity and excellent specificity for detection of Integrin Alpha 9 (ITGa9). No significant cross-reactivity or interference between Integrin Alpha 9 (ITGa9) and analogues was observed.
- Sensitivity
- 0.058 ng/mL
- Featured
- Discover our best selling ITGA9 ELISA Kit
-
-
- Comment
-
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
- Assay Time
- 3 h
- Plate
- Pre-coated
- Protocol
- The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Integrin Alpha 9 (ITGa9). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Integrin Alpha 9 (ITGa9). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Integrin Alpha 9 (ITGa9), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Integrin Alpha 9 (ITGa9) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
- Assay Precision
-
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Integrin Alpha 9 (ITGa9) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Integrin Alpha 9 (ITGa9) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12% - Restrictions
- For Research Use only
-
- Handling Advice
- The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.
- Storage
- 4 °C,-20 °C
- Storage Comment
- -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.
- Expiry Date
- 4-8 months
-
- Target See all ITGA9 products
- ITGA9 (Integrin alpha-9 (ITGA9))
- Alternative Name
- Integrin Alpha 9 (ITGA9 Products)
- Synonyms
- (alpha)9 ELISA Kit, 2610002H11Rik ELISA Kit, 6720458D17Rik ELISA Kit, AI461869 ELISA Kit, D130073C02 ELISA Kit, D9Ertd428e ELISA Kit, ALPHA-RLC ELISA Kit, ITGA4L ELISA Kit, RLC ELISA Kit, Itga9l ELISA Kit, integrin alpha 9 ELISA Kit, integrin subunit alpha 9 ELISA Kit, Itga9 ELISA Kit, ITGA9 ELISA Kit
- Background
-
Gene Name: Integrin Alpha 9
Gene Aliases: ITG-A9, Alpha-RLC, ITGA4L, RLC
- Gene ID
- 3680
- UniProt
- Q13797
-