C1QA ELISA Kit

Catalog No. ABIN5653206

Product Details C1QA ELISA Kit

Target: C1QA (Complement Component 1, Q Subcomponent, A Chain (C1QA))

Reactivity: Rat

Detection Method: Colorimetric

Method Type: Sandwich ELISA

Detection Range: 1.56 ng/mL - 100 ng/mL

Minimum Detection Limit: 1.56 ng/mL

Application: ELISA

Sample Type: Plasma, Serum

Analytical Method: Quantitative

Specificity: This assay has high sensitivity and excellent specificity for detection of Complement Component 1, Q Subcomponent A (C1qA). No significant cross-reactivity or interference between Complement Component 1, Q Subcomponent A (C1qA) and analogues was observed.

Sensitivity: 0.67 ng/mL

Application Details

Comment:

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay Time: 3 h

Plate: Pre-coated

Protocol: The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Complement Component 1, Q Subcomponent A (C1qA). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Complement Component 1, Q Subcomponent A (C1qA). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Complement Component 1, Q Subcomponent A (C1qA), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Complement Component 1, Q Subcomponent A (C1qA) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Assay Precision: Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Complement Component 1, Q Subcomponent A (C1qA) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Complement Component 1, Q Subcomponent A (C1qA) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Restrictions: For Research Use only

Handling

Handling Advice: The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.

Storage: 4 °C,-20 °C

Storage Comment: -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.

Expiry Date: 4-8 months

Target Details for C1QA

Target: C1QA (Complement Component 1, Q Subcomponent, A Chain (C1QA))

Alternative Name: Complement Component 1, Q Subcomponent A (C1QA Products)

Synonyms: zgc:109903 ELISA Kit, C1QA ELISA Kit, AI255395 ELISA Kit, C1q ELISA Kit, complement C1q A chain ELISA Kit, complement component 1, q subcomponent, A chain ELISA Kit, complement component 1, q subcomponent, alpha polypeptide ELISA Kit, C1QA ELISA Kit, c1qa ELISA Kit, C1qa ELISA Kit

Background:

Gene Name: Complement Component 1, Q Subcomponent A

Gene Aliases: Complement Component 1,q Subcomponent,Alpha Polypeptide

Gene ID: 298566

UniProt: P31720

Pathways: Complement System